Dell R805 owner manual Error Slot n, Plug & Play, Remote, Update attempt, Failed

Table 1-7. System Messages (continued)

Message	Causes	Corrective Actions
PCIe Training	Faulty or improperly installed	Reseat the PCIe card in the
Error: Slot n	PCIe card in the specified	specified slot number. See
	slot.	"Expansion Cards" on
		page 91. If the problem
		persists, see "Getting Help"
		on page 175.

Plug & Play	Error encountered in
Configuration	initializing PCIe device;
Error	faulty system board.

Install the NVRAM_CLR jumper and reboot the system. See Figure 6-1 for jumper location. If the problem persists, see "Troubleshooting Expansion Cards" on page 158.

Read fault

Requested sector not found

Remote Access Controller cable error or incorrect card in the RAC slot.

The operating system cannot read from the hard drive or USB device, the system could not find a particular sector on the disk, or the requested sector is defective.

RAC cables not connected, or RAC card installed in wrong expansion slot.

Replace the USB medium or device. Ensure that the USB or hard drive cables are properly connected. See "Troubleshooting a USB Device" on page 143, or "Troubleshooting a Hard Drive" on page 155 for the appropriate drive(s) installed in your system.

Check that the RAC cables are connected, and that the RAC card is installed in the correct expansion slot. See "Installing a RAC Card" on page 106.

Remote	System unable to process	Retry Remote Configuration.
configuration	Remote Configuration
update attempt	request
failed

About Your System

41