Dell R805 Alert! Node, Interleaving, Disabled! Memory, Configuration, Does not support, CPUs with

Table 1-7. System Messages

Message	Causes	Corrective Actions
Alert! Node	The memory configuration	Ensure that the memory
Interleaving	does not support node	modules are installed in a
disabled! Memory	interleaving, or the	configuration that supports
configuration	configuration has changed	node interleaving. Check
does not support	(for example, a failed	other system messages for
Node	DIMM) so that node	additional information for
Interleaving.	interleaving cannot be	possible causes. For memory
	supported. The system will	configuration information,
	run but with reduced	see "General Memory
	functionality.	Module Installation
		Guidelines" on page 114. If
		the problem persists, see
		"Troubleshooting System
		Memory" on page 150.

Attempting to	Remote Configuration
update Remote	request has been detected
Configuration.	and is being processed.
Please wait...
BIOS Update	Remote BIOS update
Attempt Failed!	attempt failed.
Caution!	NVRAM_CLR jumper is
NVRAM_CLR jumper	installed. CMOS has been
is installed on	cleared.
system board.

Wait until the process is complete.

Retry the BIOS update. If problem persists, see "Getting Help" on page 175.

Remove NVRAM_CLR jumper. See Figure 6-1 for jumper location.

CPUs with	Microprocessors with	Ensure that all
different cache	different cache sizes are	microprocessors have the
sizes detected!	installed.	same cache size and that
		they are properly installed.
		See "Processors" on page 120.
Decreasing	Faulty or improperly installed	See "Troubleshooting System
available memory	memory modules.	Memory" on page 150.

36

About Your System