carpet or similar surfaces which may restrict air circulation. If installing the fireplace in a carpeted area, place a
!NOTE: The dimensions of the fireplace with the trim are 27 ⅜ inch (695 mm) wide x 23 ½ inch (596 mm) high x 8 ¾ inch (222 mm) deep. Dimensions without trim are 26 ¼ inch (663 mm) wide x 22 ⅞ inch (580 mm) high x 8 ¾ inch (222 mm) deep. The fireplace does not require any additional venting (Figure 4).
Figure 4 | 27 ⅜” |
|
|
| |
| (695 mm) | 26 ¼” |
|
| |
|
| (663 mm) |
22 ⅞” | 23 ½” | 8 ¾” |
(580 | (596 mm) | (222 mm) |
mm) |
|
|
Fireplace Insert Installation
Install the fireplace assembly into the mantel (refer to mantel assembly instructions).
!NOTE: A 15 Amp, 120 Volt circuit is required. A dedicated circuit is preferred but not essential in all cases. A dedicated circuit will be required if after installation the circuit breaker trips or fuse blows on a regular basis when the heater is operating. Additional appliances on the same circuit may exceed the current rating of the circuit breaker.
!IMPORTANT: If not using a Dimplex mantel, the fireplace must be installed in an enclosure with the following MINIMUM dimensions
(Figure 5).
8