Documentation for any components you purchased separately provides information to configure and install these options.

Updates are sometimes included with the system to describe changes to the system, software, and/or documentation.

NOTE: Always check for updates on support.dell.com and read the updates first because they often supersede information in other documents.

Release notes or readme files may be included to provide last-minute updates to the system or documentation or advanced technical reference material intended for experienced users or technicians.

Accessing System Features During Startup

Table 1-1 describes keystrokes that may be entered during startup to access system features. If your operating system begins to load before you enter the keystroke, allow the system to finish booting, and then restart your system and try again.

Table 1-1. Keystrokes for Accessing System Features

Keystroke

Description

 

 

<F2>

Enters the System Setup program. See "Using the System Setup

 

Program" on page 48.

<F10>

Opens the utility partition, allowing you to run the system

 

diagnostics. See "Running the System Diagnostics" on page 161

<F11>

Enters the boot mode selection screen, allowing you to choose a

 

boot device.

<F12>

Starts PXE boot.

<Ctrl><E>

Enters the Baseboard Management Controller (BMC) Management

 

Utility, which allows access to the system event log (SEL) and

 

configuration of the remote access controller (RAC) card. See the

 

BMC User’s Guide for more information on setup and use of BMC.

12

About Your System

Page 12
Image 12
Dell R805 owner manual Accessing System Features During Startup