Sigma LBA-700, LBA-710, LBA-714PC, LBA-300, LBA-712 Executionerror CHR, Rem, Message Generated By

Message	Error Type	Description
crosshair mode	EXECUTION_ERROR	CHR
not set to
manual
not in remote	EXECUTION_ERROR	SYC - Cannot synchronize with
		remote if GPIB interface is in
		local mode. (see SYC, LOC,
		REM)

Following is a list of error messages that normally appear on the display. These messages are automatically rerouted to the error message queue when LBA-PC is in remote control mode.

	Message		Generated By
	Cannot run Ultracal because all frames are write		Ultracal!
	protected.
	The Camera Gain is set too high.		Ultracal!
	Camera Black Level range exceeded.		Ultracal!
	Please block the beam.		Ultracal!
	No Camera Video Input.		capture
	Cannot start running because all frames are write		capture
	protected.		post process
	Post Process file does not exist. Processing		post process
	Aborted.
	File record header does not match current		post process
	configuration. Processing Aborted.
	This is not a valid LBA-PC data file. Processing		post process
	Aborted.
	End of Post Process file. Processing Stopped.		post process
	Attempt to read beyond end of file. Processing		post process
	Aborted.
	This is not a Demo frame. Processing Aborted.		post process
	Frame %d contains no data. Processing Aborted.		post process
	Frame size of this record %ld is %d X %d. Frame		post process
	size of first record is %d X %d. Processing
	Aborted.
	Data logging file and Post Process file are the same.		post process
Operator’s Manual		246		LBA-PC