Sigma LBA-700, LBA-710 Error Messages, LBA-PC device driver not found LBA-PC set to Off-Line mode

The factory-supplied configuration files are write protected, so that you cannot accidentally lose or overwrite them. Each of these file names begin with a ~ (tilde), for easy identification. Some examples of these files are:

~lbapc.cfg	The original default configuration.
~cw_basc.cfg	A CW laser setup w/ basic results.
~cw_gaus.cfg	A CW laser setup w/ Gauss Fit results.
~cw_hist.cfg	A CW laser setup w/ Histogram display.
~cw_fram.cfg	A CW laser setup w/ 8 frame averaging.
~cw_elip.cfg	A CW laser setup w/ elliptical results.
~vt_toph.cfg	Video trigger mode for a pulsed laser w/ Top Hat results enabled.
~to5gaus.cfg	A Trigger Output at 5 Hz to fire a pulsed laser w/ Gauss Fit results.
~PYROCAM.cfg	For use with Pyrocam I’s w/o digital camera option.
~PYRODIG.cfg	For use with Pyrocam I’s w/ digital camera option.

2.2 Error Messages

The explanations of the following error messages assume that you are Windows savvy. If you find that after reading an error message’s meaning, you still do not know what to do, then contact Spiricon’s Service department for assistance.

You may encounter the following error messages:

LBA-PC device driver not found.

LBA-PC set to Off-Line mode

This error usually indicates that your LBA-PC frame grabber is either not installed or is not working. If the frame grabber card is not detected by Windows then the device driver will not be loaded when the system starts. This error may also indicate that the device driver was not properly installed. To determine the cause, do the following:

Windows 2000

•Click on… Start, Settings, Control Panel.

Or for Windows XP

•Click on… Start, Control Panel.

Then for Both

•Double click on the System icon.

•Select the Hardware tab.

•Click on the Device Manager button.

Operator’s Manual 22 LBA-PC