Sigma LBA-710, LBA-714PC, LBA-300 Connections, Frame Grabber not found LBA-PC set to Off-Line mode

The device driver was unable to allocate enough memory in order to capture video frames. This may occur the first time you boot the computer after installing the Frame Grabber card. Try rebooting the computer. If the error continues to occur you will need to add memory to the computer. LBA-PC requires a minimum 256 MB of main memory, 512 MB is recommended. If the error occurs after adding memory then contact the Spiricon Service Department.

Frame Grabber not found.

LBA-PC set to Off-Line mode.

Your LBA-PC frame grabber card is either not installed, or not working. The LBA-PC application program will complete loading, but the software will be forced to the Off-Line mode. This means you can only view files and perform Post Processing of data from and/or to data files. Check to see that your Frame Grabber card is properly installed. Contact the Spiricon Service Department for further assistance.

Not a valid LBA-PC data file.

You are attempting to load a file that is not in a format that the LBA-PC can recognize. See loadable file types.

2.3 Optional Equipment

Optional equipment can include the following items:

License:	Multi-user site software license
Adapter:	4 Camera adapter
	Digital Camera adapter
Camera:	Selected camera, specify type
	Interface cable
	BNC cable
	Camera manual (if supplied by camera manufacturer)
	Camera power supply (if supplied by camera manufacturer)
Computer:	PC compatible, Pentium or equivalent
Attenuator:	Model LBS-100, BA-VIS, -NIR, or -BB beam attenuator

2.4 Connections

This topic describes the Camera Control (upper, 9 pin D-sub, female) and Trigger I/O (lower, 9 pin D- sub male) connectors on the LBA-PC rear panel. The schematic shown below describes the circuits on these connectors. See the Specifications section for the respective drive limits of these signals.

Operator’s Manual 24 LBA-PC