Sigma LBA-500PC REM go to remote, RUN start running, STP stop running, STT start/stop toggle

A.5.4.18 REM - go to remote

When the REM message is sent or when the LBA-PC goes from local to remote via the REN line then local control is automatically locked out (equivalent to password lockout).

Note that remote logging (:LOG) or synchronization (:SYC) are allowed only when remote is enabled. If remote logging was enabled in the configuration (i.e. file name was FRM, RDD, or RDR) and you set the LBA-PC to remote, then remote logging will be re-enabled. The synchronization state is not kept in the configuration so you must send a new SYC command after the LBA-PC is in remote.

:REM

Returns:

REM

A.5.4.19 RUN - start running

This command has no effect if the LBA-PC is already running. :RUN

A.5.4.20 STP - stop running

This command has no effect if the LBA-PC is already stopped. :STP

A.5.4.21 STT - start/stop toggle

Toggle start/stop equivalent to Start/Stop on main LBA-PC menu. :STT

A.5.4.22 SYC - synchronize with remote

SYC forces the LBA-PC to wait until data, results, or both have been queried and sent before capturing another frame. This command is similar to :LOG with the file name set to FRM, RDD, or RDR, except the LBA-PC does not automatically send the response data.

:SYC <configuration>3

Key	Type	Value Description
Data	B	true = synchronize remote data download
		Do not capture another frame until the
		controller sends a :FRM? or :RDD?
		Command and reads the response data.
		false = normal operation

Operator’s Manual	261	LBA-PC
Doc. No. 10654-001, Rev 4.10