Sigma LBA-714PC manual Remote Specific Commands, Pass/fail divergence configuration, CAL ultra cal

Key	Type	Value Description
TophatSDMMinor	B,B	Min,Max test enable.
TophatSDMMinorMin	F	Tophat SD/M Y minimum.
		0 to 1e3.
TophatSDMMinorMax	F	Tophat SD/M Y maximum.
		0 to 1e3.

A.5.3.6	pass/fail divergence configuration
	Key	Type	Value Description
	DivergenceMajor	B,B	Min,Max test enable.
	DivergenceMajorMin	F	Divergence X or Major min., in milli-
			radians.
			0.0 to 3142.0.
	DivergenceMajorMax	F	Divergence X or Major max., in milli-
			radians.
			0.0 to 3142.0.
	DivergenceMinor	B,B	Min,Max test enable.
	DivergenceMinorMin	F	Divergence Y or Minor min., in milli-
			radians.
			0.0 to 3142.0.
	DivergenceMinorMax	F	Divergence Y or Minor max., in milli-
			radians.
			0.0 to 3142.0.

A.5.4 Remote Specific Commands

If a key is not specified with the command then the default value is the last value set (restore config, previous command) unless otherwise specified in the description.

Range checking is performed on all values in key=value for each transmitted command. If any value is invalid or out of range then the entire command is ignored and the range error bit is set (see :ELR?).

A.5.4.1 CAL - ultra cal

:CAL <configuration>3

If you do not send a parameter then the LBA-PC begins an automatic camera calibration process. When the process is completed the LBA-PC sets the Operation Complete bit (bit 0) in the Event Status Register (see *ESR).

Operator’s Manual	241	LBA-PC
Doc. No. 10654-001, Rev 4.10