Sigma LBA-708, LBA-710, LBA-714PC, LBA-300, LBA-712, LBA-500PC, LBA-700 manual Quantitative Results

9.3.1.16 Results

This property provides all of the LBA-PC results, except statistics, in a one-dimensional array of doubles packaged as a Variant.

The results are loaded into the array in the following order:

1.Quantitative

2.Elliptical

3.Gauss Fit – whole beam

4.Gauss Fit – major axis

5.Gauss Fit – minor axis

6.Top Hat – whole beam

7.Top Hat – major axis

8.Top Hat – minor axis

9.Divergence

This is the same order as listed in sections 3.1.15 through 3.1.19 below under individual results properties (also the same order as displayed in the LBA-PC Results Window). All results values will be loaded into the array all the time. Results not enabled in the LBA-PC will be zero. Note there are three sets of Gauss Fit and Top Hat results. Either the whole beam section, or the major and minor sections will contain valid results depending on how the LBA-PC is configured.

9.3.1.17 Quantitative Results

These properties provide individual Quantitative LBA-PC results. For more information, see chapter 6 in the LBA-PC Operator’s Manual.

	Property Name		LBA-PC Result
	QuantFrameTotal		Total
	QuantApertureFrac		% in Aperture
	QuantPeak		Peak
	QuantValley		Min
	QuantPeakLocX		Peak Loc X
	QuantPeakLocY		Peak Loc Y
	QuantCentroidX		Centroid X
	QuantCentroidY		Centroid Y
	QuantRadius
	QuantBeamWidthX		Width X (Width Major)
Operator’s Manual		164		LBA-PC