Manuals / Brands / Computer Equipment / Switch / Cabletron Systems / Computer Equipment / Switch

Cabletron Systems 9E132-15, 9E133-36, 9E138-12, 9E138-36b The Reset Switch

1 36

Download 36 pages, 395.36 Kb

2-5

Installing the Modules

The Reset Switch

The Reset switch is located on the front panel, under the top plastic tab, as shown

in Figure 2-4. (Under the right-side tab on the 9E138-36.) It serves two functions:

• Pressing the Reset switch twice within three seconds causes the processor

(i960) to reset.

• Pressing and holding the switch on for three or more seconds causes the

module to shutdown. Pressing and holding again for three seconds restarts the

module.

SNMP management may be used to disable this switch to enhance module

security.

Figure 2-4. The Reset Switch

SMB CPU

Reset Switch

Contents

Main Page i Notice Notice Notice ii FCC Notice DOC Notice VCCI Notice DECLARATION OF CONFORMITY ADDENDUM Page Contents Contents Page Chapter 1 Introduction Features Page Introduction 9E138-36 ETHERNET 3 Figure 1-1. The Ethernet MicroLan Switch Modules Related Manuals Getting Help Chapter 2 Installing the Modules Page Installing EPIMs EPIM Revisions Installing the EPIM The Reset Switch User-Accessible Components Setting the Module Card DIP Switch Page Chapter 3 Operation Flexible Network Bus (FNB) SMB-10 Bus SMB-1 Bus System Management Buses System Diagnostic Controller FNB Interface DC/DC Converter i960 Core 4-1 Chapter 4 LANVIEW LEDs LANVIEW LEDs 4-2 The functions of the System Management Bus (SMB) and CPU LEDs are listed in Table 4-1. The function of the FNB Transmit LED is listed in Table 4-3. The function of the FNB Receive LED is listed in Table 4-2. The functions of the Ethernet Receive LEDs are listed in Table 4-4. The function of the Link LEDs is listed in Table 4-6. The functions of the Ethernet Transmit LEDs are listed in Table 4-5. Page Chapter 5 Specications Safety Service Physical Dimensions Weight Environment Appendix A EPIMs EPIM-T EPIM-F1 and EPIM-F2 EPIM-F3 Page EPIM-C Connector Type Grounding EPIM-A and EPIM-X (AUI Port)