Manuals / Brands / Computer Equipment / Switch / Cabletron Systems / Computer Equipment / Switch

Cabletron Systems 9E132-15, 9E133-36, 9E138-12, 9E138-36b Installing the EPIM

1 36

Download 36 pages, 395.36 Kb

Installing the Modules

2-4

Installing the EPIM

To install an EPIM:

1. Remove the coverplate or the EPIM (whichever applies).

2. Slide your new EPIM into place, making sure the connectors on the rear of the

module and inside the HUB attach properly. Refer to Figure 2-3.

3. Install the mounting screw.

Figure 2-3. Installing an EPIM

When removing an EPIM, make sure to pull the module straight out so as not to

damage the connector.

NOTE

EPIM

Mounting

Screw

Contents

Main Page i Notice Notice Notice ii FCC Notice DOC Notice VCCI Notice DECLARATION OF CONFORMITY ADDENDUM Page Contents Contents Page Chapter 1 Introduction Features Page Introduction 9E138-36 ETHERNET 3 Figure 1-1. The Ethernet MicroLan Switch Modules Related Manuals Getting Help Chapter 2 Installing the Modules Page Installing EPIMs EPIM Revisions Installing the EPIM The Reset Switch User-Accessible Components Setting the Module Card DIP Switch Page Chapter 3 Operation Flexible Network Bus (FNB) SMB-10 Bus SMB-1 Bus System Management Buses System Diagnostic Controller FNB Interface DC/DC Converter i960 Core 4-1 Chapter 4 LANVIEW LEDs LANVIEW LEDs 4-2 The functions of the System Management Bus (SMB) and CPU LEDs are listed in Table 4-1. The function of the FNB Transmit LED is listed in Table 4-3. The function of the FNB Receive LED is listed in Table 4-2. The functions of the Ethernet Receive LEDs are listed in Table 4-4. The function of the Link LEDs is listed in Table 4-6. The functions of the Ethernet Transmit LEDs are listed in Table 4-5. Page Chapter 5 Specications Safety Service Physical Dimensions Weight Environment Appendix A EPIMs EPIM-T EPIM-F1 and EPIM-F2 EPIM-F3 Page EPIM-C Connector Type Grounding EPIM-A and EPIM-X (AUI Port)