Cisco Systems 15216 EDFA2 manual Set-Th-Eqpt, CommandSET-TH-EQPT

Chapter 9 TL1 Commands

		TL1 Commands and Autonomous Messages
F I N A L D R A F T - C I S C O C O N F I D E N T I A L
Table 9-53 SET-TH-ENV Syntax Description (continued)
Parameter	Syntax	Description
threshholdtype		Type of threshold that is to be set. The threshold is set to the
and		thresholdvalue that follows the comma. Possible to specify
thresholdvalue		values for one or more of the following:
pairs
	PWRBUSMIN	Power bus minimum voltage
		(cerent15216EdfaPowerBusDCVoltageMin).
		thresholdvalue can be between 350 and 700, with default of
		400, in units of –10 VDC.
		The power bus threshold has a 1.0V tolerance and a 1.0V
		hysteresis. If the minimum threshold is configured at 400 (-40
		VDC), the alarm will not raise until the voltage goes below -39
		VDC and will not clear until the voltage goes above -41VDC.
	PWRBUSMAX	Power bus maximum voltage
		(cerent15216EdfaPowerBusDCVoltageMax).
		thresholdvalue can be between 350 and 700, with default of
		570, in units of –10 VDC.
		The power bus threshold has a 1.0V tolerance and a 1.0V
		hysteresis. If the maximum threshold is configured at 570 (-57
		VDC), the alarm will not raise until the voltage goes above -58
		VDC and will not clear until the voltage goes below -56 VDC.

9.7.47 SET-TH-EQPT

CommandSET-TH-EQPT

Sets general threshold values for the ONS 15216 EDFA2.

SyntaxSET-TH-EQPT:[<tid>]:<aid>:<ctag>::<thresholdtype>,<thresholdvalue>[,,];

Example 9-50 SET-TH-EQPT Command

Amp01:ONS15216 EDFA2> SET-TH-EQPT:Amp01:ALL:123::MAXCTMP,60;

Table 9-54 SET-TH-EQPT Syntax Description

Parameter	Syntax	Description
aid		EQPT and ALL have same input effect.
	EQPT	General parameters of the ONS 15216 EDFA2 (not directly
		affecting optical signal or power bus).
	ALL	Any or all of the preceding (command input only).

Cisco ONS 15216 EDFA2 Operations Guide

78-16033-01 9-63