Chapter 4 Provisioning Using ASH and SNMP

Add Users

F I N A L D R A F T - C I S C O C O N F I D E N T I A L

Password =

****

New Password =

******

Confirm New Password =

******

Note The default user name for the administrator level is CISCO15 with no default password. To start a session for this user name, press Enter.

4.10 Add Users

Use the user entry create command to add new users to the ONS 15216 EDFA2. The syntax is to enter the command followed by the user name and then the access level (read, read_write, read_write_admin) as shown in Example 4-10. The ONS 15216 EDFA2 responds with a request for the password.

Passwords must be an ASCII string of up to 10 characters, where at least 2 are non-alphabetic characters with at least one special character. Special characters are +, #, and % (defined in Telcordia GR-831-CORE).

Example 4-10 Adding a New User

ash:hostname:ONS15216 EDFA2> user entry create janedoe read_write

New Password =

*********

Confirm New Password =

*********

4.11 Save Changes

To ensure that the provisioning changes are set, you must save your changes prior to terminating the session. To save changes, use the snmp attribute set local cerent15216EdfaOpSaveConfig perform command (Example 4-11).

Example 4-11 Saving Changes

ash:hostname:ONS15216 EDFA2> snmp attribute set local cerent15216EdfaOpSaveConfig perform

Most SNMP configuration attributes require the above save command before terminating the session (does not apply to TL1 shell). The exceptions to this save requirement (the attributes that are automatically saved) are shown below:

cerent15216EdfaPowerBusMode

cerent15216EdfaPowerBusDCVoltageMin

cerent15216EdfaPowerBusDCVoltageMax

cerent15216EdfaPumpCfgControlMode and the corresponding pump control value

cerent15216EdfaConstGainOverallGain

cerent15216EdfaVariableGainPreAttenuation

SromIpMgmtGroup attributes:

cerent15216EdfaSromIpMgmtEnetAddress

Cisco ONS 15216 EDFA2 Operations Guide

 

78-16033-01

4-11

 

 

 

Page 59
Image 59
Cisco Systems 15216 EDFA2 manual Add Users, Save Changes, Example 4-10 Adding a New User, Example 4-11 Saving Changes