Cisco Systems 15216 EDFA2 manual N a L D R a F T C I S C O C O N F I D E N T I a L

Chapter 5 SNMP MIB Installation and Configuration

Tables and Groups

F I N A L D R A F T - C I S C O C O N F I D E N T I A L

Table 5-6 cerent15216EdfaCfgGroup Variable Descriptions (continued)

		Maximum
Variable	Syntax	Access	Description
cerent15216EdfaCLEI	Display String	Read-only	Indicates the factory setting of the
	(0 to 10		Common Language Equipment
	characters)		Identifier (CLEI) code (established by
			Telcordia) of the Cisco
			ONS 15216 EDFA2. This attribute
			can be accessed but not changed by
			the user.
cerent15216EdfaPowerBus	cerent15216Edfa	Read-write	Simplex for one power source (Bus
Mode	PowerBusMode		A) or duplex for redundant power
			source (Bus A and Bus B) Power Bus
			mode.
cerent15216EdfaPowerBus	Integer	Read-write	Minimum allowable power bus DC
DCVoltageMin	(350 to 700)		voltage. The default maximum power
			bus voltage is set at –40 VDC. Valid
			entries are between 350 and 700 and
			are in negative volts times 10. For
			example, if the voltage required is –40
			VDC, the power bus setting is 400.
			The power bus threshold has a 1.0V
			tolerance and a 1.0V hysteresis. If the
			minimum threshold is configured at
			400 (-40 VDC), the alarm will not
			raise until the voltage goes below -39
			VDC and will not clear until the
			voltage goes above -41 VDC.
cerent15216EdfaPowerBus	Integer	Read-write	Maximum allowable power bus DC
DCVoltageMax	(350 to 700)		voltage. The default maximum power
			bus voltage is set at –57 VDC. Valid
			entries are between 350 and 700 and
			are in negative volts times 10. For
			example, if the voltage required is –57
			VDC, the power bus setting is 570.
			The power bus threshold has a 1.0V
			tolerance and a 1.0V hysteresis. If the
			maximum threshold is configured at
			570 (-57 VDC), the alarm will not
			raise until the voltage goes above -58
			VDC and will not clear until the
			voltage goes below -56 VDC.

Use the snmp attribute set local cerent15216EdfaOpSaveConfig perform command to save changes.

Cisco ONS 15216 EDFA2 Operations Guide

78-16033-01 5-13