Cisco Systems 15216 EDFA2 manual Apply, Softwareload, Softwarereset, CommandAPPLY

Chapter 9 TL1 Commands

TL1 Commands and Autonomous Messages

F I N A L D R A F T - C I S C O C O N F I D E N T I A L

Table 9-10 ALW-MSG-ALL Syntax Description (continued)

Parameter	Syntax	Description
	GAINCHGD	“Overall Gain Changed”
		(cerent15216EdfaConstGainOverallGain).
	LOSHYSTCHGD	“LOS (loss of signal) Hysteresis Changed”
		(cerent15216EdfaLOSHysteresis).
	LOSTHCHGD	“LOS (loss of signal) Threshold Changed”
		(cerent15216EdfaLOSThreshold).
	LPOUTCHGD	“Loss of Output Power Setpoint Changed”
		(cerent15216EdfaLpoutSetpoint).
	LPOUTDEVCHGD	“Lpout (loss of output power) Deviation Changed”
		(cerent15216EdfaLpoutDeviation).
	LPOUTHYSTCHGD	“Lpout (loss of output power) Hysteresis Changed”
		(cerent15216EdfaLpoutHysteresis).
	PREATTCHGD	“Pre-attenuation Changed”
		(cerent15216EdfaVariableGainPreAttenuation).
	PWRBUSMAXCHGD	“Power Bus Max (voltage) Changed”
		(cerent15216EdfaPowerBusDCVoltageMax).
	PWRBUSMINCHGD	“Power Bus Min (voltage) Changed”
		(cerent15216EdfaPowerBusDCVoltageMin).
	PWRBUSMODE	“Power Bus Mode Changed”
		(cerent15216EdfaPowerBusMode).
	MAXCTMPCHGD	“Max Case Temperature Changed”
		(cerent15216EdfaCtmpMax).
	MAXCTMPHYSTCHGD	“Max Ctmp (case temperature) Hysteresis Changed”
		(cerent15216EdfaCtmpMaxHysteresis).
	MINCTMPCHGD	“Min Case Temperature Changed”
		(cerent15216EdfaCtmpMin).
	MINCTMPHYSTCHGD	“Min Ctmp (case temperature) Hysteresis Changed”
		(cerent15216EdfaCtmpMinHysteresis).
	CUTOVERRESET	(Software) “Reset after Cutover”
		(cerent15216EdfaOpCutover).
	SOFTWARELOAD	(New) “Software Load” (cerent15216EdfaOpLoad).
	SOFTWARERESET	“Software Reset” (cerent15216EdfaOpReset).
	ALL	All condtype preceding.

9.7.3 APPLY

CommandAPPLY

Applies a software cutover in the memory. There are two boot file entries. This command exchanges boot file entries 1 and 2 so that when the system is restarted (by the INIT-SYScommand), it boots with the image that was (before the execution of this command) at the second entry.

Cisco ONS 15216 EDFA2 Operations Guide

78-16033-01 9-11