PROBLEM | POSSIBLE CAUSE | SOLUTION | |
Load is Wrinkled | Not removing load promptly. | Unload the washer as soon as it stops. | |
|
|
| |
| Wrong cycle for fabrics being | Use cold rinses and cycles with slow spin | |
| washed. | speeds to reduce wrinkling. | |
|
|
| |
| Overloading. | Loads should move freely during wash. | |
|
| Wash smaller loads. | |
|
|
| |
| Wash water not warm enough | Use Automatic Temperature Control | |
| to relax wrinkles. Using warm | (ATC) if safe for fabric, use warm or hot | |
| rinses. | wash water. Use cold rinse water. | |
|
|
| |
| Hoses reversed. | Reverse hoses (see Installation Instruc- | |
|
| tions, Section One.) | |
|
|
| |
Load is Tangled/ | Overloading. | Loads should move freely during wash. | |
Twisted |
| Wash smaller loads. | |
|
|
| |
Clogged Dispensers/ | Use of | Add | |
Bleach Leaking/ | rine bleach dispenser | dispenser. Do not use chlorine bleach | |
Bleach on Wrong |
| dispenser. | |
Loads |
|
| |
Improper use of chlorine bleach | Always measure bleach before adding | ||
| |||
|
| to the dispenser. Carefully pour into the | |
|
| dispenser. Wipe up bleach stains. | |
|
|
|
ERROR CODES
Power Failure | P F | “PF” flashes if the washer loses power during a running cycle. The washer does not flash | |
“PF” when it is first plugged in. | |||
| |||
|
| ||
|
| Press START to continue the cycle from the moment that power was lost | |
|
| Press STOP/CANCEL to clear the display and completely cancel the cycle. | |
|
|
| |
Flood Condition | F L | “FL” flashes if any overfill condition occurs. This condition occurs when excessive water in | |
the tub causes the overfill switch to trip. The control must realize that the trip was due to an | |||
|
| overfill condition instead of a suds lock condition in order for “FL” to be displayed. | |
|
| With an overfill condition, the beeper repeats a warning every 10 seconds with no time out. | |
|
| The pump is cycled in drain mode for 30 seconds on, 30 seconds off until the overfill switch | |
|
| resets or power is discontinued to the unit. | |
|
| Press STOP/CANCEL to clear the display. | |
|
|
| |
Processor Reset | E r | This error code is displayed if the control failed to save cycle information during a power | |
Error | failure. This does not generate an error code beep. | ||
| |||
|
| ||
|
| Press STOP/CANCEL to clear the display. | |
|
|
| |
Long Fill | L F | If the water fill time exceeds ten (10) minutes, the water valves are turned off and “LF” is | |
flashed. | |||
| |||
|
| ||
|
| Press STOP/CANCEL to clear the display. | |
|
|
|
46
