THERMISTOR RESISTANCE CHART
THERMISTOR RESISTANCE
TEMP | RESISTANCE VALUE | |
° F |
|
|
|
|
|
40 | 126k | - 135k ohms |
50 | 97k - 102k ohms | |
60 | 75k | - 78k ohms |
70 | 58k | - 61k ohms |
80 | 46k | - 47k ohms |
90 | 36k | - 37k ohms |
100 | 28k | - 30k ohms |
110 | 23k | - 24k ohms |
120 | 18k | - 19k ohms |
130 | 15k | - 16k ohms |
140 | 12k | - 13k ohms |
150 | 10k - 11k ohms | |
|
|
|
Additional Options
| DESCRIPTIONS |
|
|
OPTIONS |
|
|
|
Soak | Loosens soils when added to a cycle. Selection of |
| SOAK will add approximately 16 minutes to the wash |
| portion of the cycle. |
Extra Rinse | Adds an additional rinse to any cycle. |
Extend Spin | Adds three, (3), minutes to the final spin time of any |
| cycle. |
|
|
End of Cycle Signal
There are three (3) volume levels for the End of Cycle Signal, HIGH, LOW and OFF. Pressing the END OF CYCLE SIGNAL keypad toggles between these options by lighting one of the LEDs and beeping the corresponding end of cycle signal at the volume level selected. The LED remains lit during program mode and running mode until the cycle is complete.
If OFF is selected, no end of cycle signal will beep, but all key and warning beeps are active.
The end of cycle signal is set at a short high pitched, followed by a longer lower pitched tone, repeated four times.
10
