Remove the connector at the motor and take measurements as shown in the following table.

Recirc to Neutral

10 - 12

RD to WH

Drain to Neutral

10 - 12

YL to WH

Recirc to Drain

20 - 25

RD to YL

If the resistance is much higher than shown, replace the pump motor.

If the resistance at the pump motor is correct, there is an open circuit in the wiring between the motor and the motor controller. Repair or replace the lower wiring harness.

If the pump motor windings and motor controller are OK, repair or replace the pump.

59

Page 63
Image 63
Whirlpool GVW9959K-0 manual