Cisco Systems 15216 EDFA2 manual Example 8-8shows sample command outputs

Chapter 8 Provisioning Using TL1

Set Alarm Thresholds

F I N A L D R A F T - C I S C O C O N F I D E N T I A L

Figure 8-1 ONS 15216 EDFA2 Front Panel

Fiber	Fiber	Status
input	output			Alarm
port	port	LEDs		out
-48V A		POWER		-48V B
		FAIL	CISCO ONS 15216	ALARM OUT
				RS-232
				LAN
		LOS
R A				R B

71176

-48V A	Fiber	Power	RS-232	LAN port	-48V B
RET A	output	level	(EIA/TIA-232) LAN LEDs		RET B
	monitor	warning
	port

Alarms are reported for the following conditions:

•Degradation of electrical power source

•Laser pump overheating or excessive pump current

•Loss or degradation of optical input (signal)

•Loss of output power or gain out of range

•Case temperature out of range

Alarms can be connected to a NOC NMS via a network element miscellaneous discrete input and/or office alarm panel/system.

For a full description of alarm threshold command attributes, refer to Chapter 9, “TL1 Commands.”

To display the alarm thresholds, use the RTRV-TH-DWDMand RTRV-TH-EQPTcommands (see

“RTRV-TH-DWDM” section on page 9-55and “RTRV-TH-EQPT” section on page 9-57) according to the following syntax:

RTRV-TH-DWDM:[<tid>]:<aid>:<ctag>::[<thresholdtype>][,][,]; <sid> <date> <time>

M <ctag> COMPLD "<aid>,DWDM:<thresholdtype>,,,<thresholdvalue>"

RTRV-TH-EQPT:[<tid>]:<aid>:<ctag>::[<thresholdtype>][,][,]; <sid> <date> <time>

M<ctag> COMPLD "<aid>:<thresholdtype>,,,<thresholdvalue>"

Example 8-8shows sample command outputs.

Example 8-8 Displaying the Alarm Thresholds Using TL1

sidtidname:ONS15216 EDFA2> RTRV-TH-DWDM::ALL:124;

sidtidname 2002-07-11 11:15:19

M124 COMPLD "1,DWDM:LOSTH,,,-3000" "1,DWDM:LOSHYST,,,5"

"1,DWDM:LPOUTDEV,,,1000"

"1,DWDM:LPOUTHYST,,,5"

"1,DWDM:LPOUTSETPT,,,0"

;

sidtidname:ONS15216 EDFA2> RTRV-TH-EQPT::ALL:125;

Cisco ONS 15216 EDFA2 Operations Guide

8-6 78-16033-01