Cisco Systems 15216 EDFA2 manual Rtrv-Cond-Eqpt, CommandRTRV-COND-EQPT

Chapter 9 TL1 Commands

TL1 Commands and Autonomous Messages

F I N A L D R A F T - C I S C O C O N F I D E N T I A L

9.7.31 RTRV-COND-EQPT

CommandRTRV-COND-EQPT

Generates a report on the condition (state) of general alarms.

SyntaxRTRV-COND-EQPT:[<tid>]:<aid>:<ctag>::[<condtype>][,,,];

<sid> <date> <time>

M<ctag> COMPLD "<aid>:<ntfcncde>,<condtype>,<srveff>,<ocrdat>,<ocrtm>,,,<conddescr>"

;

Example 9-33 RTRV-COND-EQPT Command and Response

Amp01:ONS15216 EDFA2> RTRV-COND-EQPT:Amp01:ALL:229::LCRNT1;

Amp01 2002-06-20 14:30:00

M 229 COMPLD "EQPT:MN,LCRNT1,NSA,6-20,14-25-30,,,\"Excessive Pump1 Current\""

;

Table 9-38 RTRV-COND-EQPT Syntax Description

Parameter	Syntax	Description
aid		EQPT and ALL have same input effect.
	EQPT	General parameters of the ONS 15216 EDFA2 (not directly
		affecting optical signal or power bus).
	ALL	Any or all of the preceding (command input only).
conddescr		Detailed text description of the event. The conddescr is 1 to 64
		characters of ASCII text. See condtype below.
condtype		Condition type identifies the type of alarm (maps to
		cerent15216EdfaLogEventID). Possible condtype and
		corresponding conddescr (in quotes) are:
	CTMP	“Case Temperature Out of Range” alarm
		(cerent15216EdfaAlarmCtmp).
	LCRNT1	“Excessive Pump1 Current” alarm
		(cerent15216EdfaAlarmLcrnt1).
	LCRNT2	“Excessive Pump2 Current” alarm
		(cerent15216EdfaAlarmLcrnt2).
	LTMP1	“Excessive Pump1 Temperature” alarm
		(cerent15216EdfaAlarmLtmp1).
	LTMP2	“Excessive Pump2 Temperature” alarm
		(cerent15216EdfaAlarmLtmp2).
date	yyyy-mm-dd	Date of origination of TL1 message.

Cisco ONS 15216 EDFA2 Operations Guide

9-46 78-16033-01