Cisco Systems 15216 EDFA2 manual Rept EVT Dwdm CTRLMODE1, Rept EVT Dwdm CTRLMODE2

Chapter 9 TL1 Commands

Summary of Autonomous Alarms and Messages

F I N A L D R A F T - C I S C O C O N F I D E N T I A L

1.The messages for Loss of Signal (LOS), Gain Out of Range (GAIN), and Loss of Output Power (LPOUT) are prioritized (in the order just listed) so that only one message can be delivered at one time. For example, if the ONS 15216 EDFA2 detects both a loss of input signal and a loss of output power at the same time, it will deliver only the Loss of Signal (LOS) message to the user. This prioritized filtering of alarms does not occur with the SNMP delivery of alarms of the ONS 15216 EDFA2.

2.A single power bus alarm is Minor. If the power system is in duplex mode and an alarm is raised on both power buses, the second alarm is Critical.

Table 9-5 on page 9-4summarizes the ONS 15216 EDFA2 autonomous events.

Table 9-5 TL1 Autonomous Events

					Access	Condition
		TL1 Autonomous	Condition Type	Condition Descriptor	Identifier	Effect
		Message	(condtype)	(conddescr)	(aid)	(condeff)
		REPT EVT DWDM	CTRLMODE1	Pump1 Control Mode	1	TC
				Changed
		REPT EVT DWDM	CTRLMODE2	Pump2 Control Mode	1	TC
				Changed
		REPT EVT DWDM	GAINCHGD	Overall Gain Changed	1	TC
		REPT EVT DWDM	LOSHYSTCHGD	LOS (loss of signal)	1	TC
				Hysteresis Changed
		REPT EVT DWDM	LOSTHCHGD	LOS (loss of signal)	1	TC
				Threshold Changed
		REPT EVT DWDM	LPOUTCHGD	Loss Of Output Power	1	TC
				Setpoint Changed
		REPT EVT DWDM	LPOUTDEVCHGD	Lpout (loss of output	1	TC
				power) Deviation Changed
		REPT EVT DWDM	LPOUTHYSTCHGD	Lpout (loss of output	1	TC
				power) Hysteresis Changed
		REPT EVT DWDM	PREATTCHGD	Pre-attenuation Changed	1	TC
		REPT EVT ENV	PWRBUSMAXCHGD	Power Bus Max (voltage)	PWR-A	TC
				Changed
		REPT EVT ENV	PWRBUSMINCHGD	Power Bus Min (voltage)	PWR-A	TC
				Changed
		REPT EVT ENV	PWRBUSMODE	Power Bus Mode Changed	PWR-B	TC
		REPT EVT EQPT	MAXCTMPCHGD	Max Case Temperature	EQPT	TC
				Changed
		REPT EVT EQPT	MAXCTMPHYSTCHGD	Max Ctmp (case temperature)	EQPT	TC
				Hysteresis Changed
		REPT EVT EQPT	MINCTMPCHGD	Min Case Temperature	EQPT	TC
				Changed
		REPT EVT EQPT	MINCTMPHYSTCHGD	Min Ctmp (case temperature)	EQPT	TC
				Hysteresis Changed
		REPT EVT EQPT	CUTOVERRESET	(Software) Reset After	EQPT	TC
				Cutover
	Cisco ONS 15216 EDFA2 Operations Guide
9-4						78-16033-01