Cisco Systems 15216 EDFA2 manual Example 4-8 Displaying the Alarm Thresholds

Chapter 4 Provisioning Using ASH and SNMP

Set Alarm Thresholds

F I N A L D R A F T - C I S C O C O N F I D E N T I A L

Figure 4-1 ONS 15216 EDFA2 Front Panel

Fiber	Fiber	Status
input	output			Alarm
port	port	LEDs		out
-48V A		POWER		-48V B
		FAIL	CISCO ONS 15216	ALARM OUT
				RS-232
				LAN
		LOS
R A				R B

71176

-48V A	Fiber	Power	RS-232	LAN port	-48V B
RET A	output	level	(EIA/TIA-232) LAN LEDs		RET B
	monitor	warning
	port

Alarms are reported for the following conditions:

•Loss or degradation of electrical power

•Laser pump overheating, excessive pump current

•Loss or degradation of optical input

Alarms can be connected to a network operations center (NOC) network management system (NMS) via a network element miscellaneous discrete input and/or office alarm panel/system.

For a full description of alarm threshold command attributes, refer to Chapter 5, “SNMP MIB

Installation and Configuration” or Chapter 6, “ASH Commands.”

To display the alarm thresholds, use the snmp table display local cerent15216EdfaCfgGroup command (Example 4-8). This command returns the current alarm threshold default values.

Example 4-8 Displaying the Alarm Thresholds

ash:hostname:ONS15216 EDFA2> snmp table display local cerent15216EdfaCfgGroup

CLASS CERENT-15216-EDFA-MIB.cerent15216EdfaCfgGroup ::=

{

cerent15216EdfaCfgSaved = false; cerent15216EdfaLpoutSetpoint = 0; cerent15216EdfaLpoutDeviation = 200; cerent15216EdfaLpoutHysteresis = 100; cerent15216EdfaLOSThreshold = -2600; cerent15216EdfaLOSHysteresis = 100; cerent15216EdfaCtmpMin = -5; cerent15216EdfaCtmpMinHysteresis = 1; cerent15216EdfaCtmpMax = 65; cerent15216EdfaCtmpMaxHysteresis = 1; cerent15216EdfaCLEI = ""; cerent15216EdfaPowerBusMode = duplex; cerent15216EdfaPowerBusDCVoltageMin = 410; cerent15216EdfaPowerBusDCVoltageMax = 560;

};

To set the alarm thresholds, use the snmp row set local cerent15216EdfaCfgGroup command. After this command is entered, the user is prompted to modify each attribute, row by row, until all attributes are set. Alarm threshold attributes are described in Table 4-1 on page 4-7.

Cisco ONS 15216 EDFA2 Operations Guide

4-6 78-16033-01