Cisco Systems manual Summary of Snmp Alarms, 17summarizes the ONS 15216 EDFA2 Snmp alarms

Chapter 5 SNMP MIB Installation and Configuration

Summary of SNMP Alarms

F I N A L D R A F T - C I S C O C O N F I D E N T I A L

For information about all of the parameters in the cerent15216EdfaAlarmEntry table, refer to Table 5-11 on page 5-19.

5.7 Summary of SNMP Alarms

Table 5-17summarizes the ONS 15216 EDFA2 SNMP alarms.

Table 5-17 SNMP Alarms

Alarm Index	Alarm ID	Description	Priority
1	lcrnt1	Excessive pump current for pump 1. Drive current	Minor
		greater than 95% of end of life value. Current must drop
		to 90% of end of life value for alarm to clear.
2	lcrnt2	Excessive pump current for pump 2. Drive current	Minor
		greater than 95% of end of life value. Current must drop
		to 90% of end of life value for alarm to clear.
3	ltmp1	Pump 1 laser temperature out of range. Chip	Minor
		temperature deviating more than 10 degrees C from the
		manufacturer-defined setpoint.
4	ltmp2	Pump 2 laser temp. out of range. Chip temperature	Minor
		deviating more than 10 degrees C from the
		manufacturer-defined setpoint.
5	lpout	Loss of output power. EDFA output power is deviating	Major
		more than the value of cerent15216EdfaLpoutDeviation
		from the value of cerent15216EdfaLpoutSetpoint. This
		alarm is only valid for constOutputPower and idle
		modes.
6	lpin	Loss of input power (signal). EDFA input power is	Major
		below the value of cerent15216EdfaLOSThreshold.
7	gain	Gain out of range. Gain has deviated more than 1.25 dB	Major
		from the setpoint in constGainTempComp mode. This
		alarm is also triggered if the input power goes outside
		the manufacturer-defined range by more than 0.15 dB.
8	ctmp	The case temperature out of the threshold range.	Minor
9	powerBusA	The Power Bus A voltage is out of the threshold range.	Minor/Critical1
		The power bus threshold has a 1.0V tolerance and a
		1.0V hysteresis. There is a ±1.5V inaccuracy in the
		ONS 15216 EDFA2 voltage measurement.
10	powerBusB	The Power Bus B voltage is out of the threshold range.	Minor/Critical1
		The power bus threshold has a 1.0V tolerance and a
		1.0V hysteresis. There is a ±1.5V inaccuracy in the
		ONS 15216 EDFA2 voltage measurement.

1.A single power bus alarm is Minor. If the power system is in duplex mode and an alarm is raised on both power buses, the second alarm is Critical.

Cisco ONS 15216 EDFA2 Operations Guide

78-16033-01 5-37