Cisco Systems 15216 EDFA2 manual User entry create Command, User entry edit Command

Chapter 6 ASH Commands

User Commands

F I N A L D R A F T - C I S C O C O N F I D E N T I A L

6.7.1 user entry create Command

Command user entry create

Syntax Description user entry create name user_mode

Creates a new user. The parameters required to create a new user are user name, access level, and password.

The user_mode (access privilege level) is set by entering either read, read_write, or read_write_admin. See Table 6-1 on page 6-1for the command privileges of each user level. The password must be an ASCII string of up to 10 characters, where at least 2 are non-alphabetic characters with at least one special character. Special characters are +, #, and %, as defined in Telcordia GR-831-CORE. See Example 6-29.

Example 6-29 user entry create Command

ash:hostname:ONS15216 EDFA2> user entry create jdoe read_write

New Password =

**********

Confirm New Password =

**********

6.7.2 user entry edit Command

Command user entry edit

Syntax Description user entry edit username

Edit a user’s parameters (name, password, and access level). This command uses the optional parameters shown at the beginning of Example 6-30. The -user_modeparameter changes the access level (read, read_write, or read_write_admin). If the password is not to be changed, hit the Enter key when the new password is requested and confirmed, as shown in Example 6-31.

Example 6-30 user entry edit Command (Change Password)

ash:hostname:ONS15216 EDFA2> user entry edit
Options
-new_user_name	(string[0..10])	new name of user
-user_mode	(string[0..16])	mode of user
Parameters
user_name	(string[0..10])	name of user
ash:hostname:ONS15216 EDFA2> user entry edit jsmith
New Password =
******
Confirm New Password	=
******

Cisco ONS 15216 EDFA2 Operations Guide

6-26 78-16033-01