Cisco Systems 15216 EDFA2 manual Input Power Signal Value

Chapter 5 SNMP MIB Installation and Configuration

Retrieving Information

F I N A L D R A F T - C I S C O C O N F I D E N T I A L

5.6.5.2.2 PowerBusDCVoltageMin

Command snmp attribute get local cerent15216EdfaPowerBusDCVoltageMin

Syntax Description snmp attribute get local cerent15216EdfaPowerBusDCVoltageMin

Displays the minimum allowable power bus DC voltage (multiplied by –10V).

The following command displays power bus voltage and other data:

•snmp row display local cerent15216EdfaCfgGroup command

5.6.6Input Power (Signal)

5.6.6.1 Input Power (Signal) Value

5.6.6.1.1 InPowerduW

Command snmp attribute get local cerent15216EdfaInPoweruW

Syntax Description snmp attribute get local cerent15216EdfaInPoweruW

Displays input power value in microwatts.

The following command displays the ONS 15216 EDFA2 input power value and other status information:

•snmp row display local cerent15216EdfaOverallStatusGroup command

For information about all of the parameters in the cerent15216EdfaOverallStatusGroup table, see Table 5-8 on page 5-17.

5.6.6.1.2 InPowerdBm

Command snmp attribute get local cerent15216EdfaInPowerdBm

Syntax Description snmp attribute get local cerent15216EdfaInPowerdBm

Displays the input power value in dBm. The dBm units are converted from µW to dBm, so theses values could be slightly different due to rounding error.

The following command displays input power value and other status information:

•snmp row display local cerent15216EdfaOverallStatusGroup command

For information about all of the parameters in the cerent15216EdfaOverallStatusGroup table, refer to Table 5-8 on page 5-17.

Cisco ONS 15216 EDFA2 Operations Guide

5-30 78-16033-01