Cisco Systems 15216 EDFA2 Rtrv-Cond-All, CommandRTRV-COND-ALL, RTRV-COND-ALL Syntax Description

Chapter 9 TL1 Commands

TL1 Commands and Autonomous Messages

F I N A L D R A F T - C I S C O C O N F I D E N T I A L

9.7.28 RTRV-COND-ALL

CommandRTRV-COND-ALL

Generates a report on the condition (state) of all alarms (except environmental alarms). Note that the ccm does not appear in the response for EQPT alarms.

Note The messages for Loss of Signal (LOS), Gain Out of Range (GAIN), and Loss of Output Power (LPOUT) are prioritized (in the order just listed) so that only one message can be delivered at one time. For example, if the ONS 15216 EDFA2 detects both a loss of input signal and a loss of output power at the same time, it will deliver only the Loss of Signal (LOS) message to the user. This prioritized filtering of alarms does not occur with the SNMP delivery of alarms of the ONS 15216 EDFA2.

SyntaxRTRV-COND-ALL:[<tid>]::<ctag>::[<condtype>][,,,];

<sid> <date> <time>

M<ctag> COMPLD "<aid>,<ccm>:<ntfcncde>,<condtype>,<srveff>,<ocrdat>,<ocrtm>,,,<conddescr>"

;

Example 9-30 RTRV-COND-ALL Command and Response

Amp01:ONS15216 EDFA2> RTRV-COND-ALL:Amp01::229::LCRNT1;

Amp01 2002-06-20 14:30:00

M229 COMPLD "1,DWDM:MJ,LOS,SA,6-20,14-25-30,,,\"Loss Of Signal\"" "EQPT,EQPT:MN,LCRNT1,NSA,6-20,14-25-30,,,\"Excessive Pump1 Current\""

;

Table 9-35 RTRV-COND-ALL Syntax Description

Parameter	Syntax	Description
aid		Possible values are:
	1	Directly affecting the optical signal.
	EQPT	General parameters of the ONS 15216 EDFA2 (not directly
		affecting optical signal or power bus).
conddescr		Detailed text description of the event. The conddescr is 1 to 64
		characters of ASCII text. See condtype below.

Cisco ONS 15216 EDFA2 Operations Guide

78-16033-01 9-41