Cisco Systems 15216 EDFA2 manual Powerbusa, Powerbusb

Chapter 9 TL1 Commands

TL1 Commands and Autonomous Messages

F I N A L D R A F T - C I S C O C O N F I D E N T I A L

Table 9-10 ALW-MSG-ALL Syntax Description

		Parameter	Syntax	Description
		ntfncde		Notification code of the alarm or event that is to be
				allowed (maps to cerent15216EdfaAlarmPriority for
				active alarms). A null maps to none of the codes, i.e.,
				with a null, all existing ntfncde inhibitions are kept
				unchanged. Possible values are:
			CR	Critical alarm.
			MJ	Major alarm.
			MN	Minor alarm.
			NA	No alarm.
			CL	Cleared alarm.
		condtype		Condition type of the alarm or event that is to be allowed.
				(Maps to cerent15216EdfaLogEventID.) ALL maps to
				all types. A null maps to none of the types, i.e., with a
				null, all existing condtype inhibitions are kept
				unchanged. Possible condtype and corresponding
				conddescr (in quotes) are:
			LOS	“Loss of Signal” (input power) alarm
				(cerent15216EdfaAlarmLpin).
			GAIN	“Gain Out of Range” alarm
				(cerent15216EdfaAlarmGain).
			LPOUT	“Loss of Output Power” alarm
				(cerent15216EdfaAlarmLpout).
			CTMP	“Case Temperature Out of Range” alarm
				(cerent15216EdfaAlarmCtmp).
			LCRNT1	“Excessive Pump1 Current” alarm
				(cerent15216EdfaAlarmLcrnt1).
			LCRNT2	“Excessive Pump2 Current” alarm
				(cerent15216EdfaAlarmLcrnt2).
			LTMP1	“Excessive Pump1 Temperature” alarm
				(cerent15216EdfaAlarmLtmp1).
			LTMP2	“Excessive Pump2 Temperature” alarm
				(cerent15216EdfaAlarmLtmp2).
			POWERBUSA	“Power Bus A (voltage) Alarm”
				(cerent15216EdfaAlarmPowerBusA).
			POWERBUSB	“Power Bus B (voltage) Alarm”
				(cerent15216EdfaAlarmPowerBusB).
			CTRLMODE1	“Pump1 Control Mode Changed”
				(cerent15216EdfaControlMode for
				cerent15216EdfaPumpCfgPumpNumber=1).
			CTRLMODE2	“Pump2 Control Mode Changed”
				(cerent15216EdfaControlMode for
				cerent15216EdfaPumpCfgPumpNumber=2).
	Cisco ONS 15216 EDFA2 Operations Guide
9-10				78-16033-01