Removing Older Power Supplies
Figure 11 Supporting the New Power Suppl
AC | FAN | OUTPUT |
OK | OK | |
| FAIL |
H5267
I
0
Step 2 Use the large slotted screwdriver to tighten the captive screw that secures the power supply to the chassis frame. (See .)
Figure 12 Location of Captive Installation Screws on the New Power Supply
AC | FAN | OUTPUT |
OK | OK | FAIL |
AC | FAN | OUTPUT |
OK | OK | FAIL |
POWER
B
I
I
0 0
H5265
Captive screws
Step 3 Reconnect the power cable to the power receptacle on the power supply.
Warning This unit might have more than one power cord. To reduce the risk of electric shock, disconnect the two power supply cords before servicing the unit. (To see translated versions of this warning, refer to page 19.)
Note The new
Step 4 After the AC power cable is reconnected, reconnect the power cable at the power source but do not turn ON power to the new power supply.
Step 5 If you are replacing both power supplies, repeat Steps 1 through 3 for the second power supply.
This completes the installation procedure for the new power supplies.
Proceed to the following section “ Checking the New Power Supply Installation” to apply power and check the installation.
Upgrading the
| 17 |
| |
|
|