Removing Older Power Supplies
Figure 9 Supporting the Older Power Supply
AC | FAN OUTPUT | |
| ||
OK | OK | FAIL |
|
H3029
I
0
Step 6 If you have a second power supply, repeat steps 1 through 5 to remove it.
Caution To maintain agency compliance requirements and meet EMI emissions standards in a Cisco 7513 chassis with a single power supply, the power supply blank must remain in the power supply bay adjacent to the power supply. (See .) Do not remove this blank from the chassis unless you do so to install a redundant power supply. To prevent system problems, do not mix
Figure 10 Power Supply Blank
H3539
Captive screw
This completes the removal procedure for the older power supplies.
Installing New Power Supplies
Follow these steps to install a new power supply (Part Number
Step 1 Hold the supply as shown in and slide it into the power supply bay. Push the supply all the way into the chassis until the sides are flush against the chassis frame. To prevent damaging the backplane connector, do not jam the power supply into the bay.
Upgrading the
16 |
| |
|