Cisco Systems 15216 EDFA2 manual Set IP Address, Log In via LAN Port Using Telnet Optional

Chapter 4 Provisioning Using ASH and SNMP

Set IP Address

F I N A L D R A F T - C I S C O C O N F I D E N T I A L

4.2 Set IP Address

Before connecting the ONS 15216 EDFA2 to a LAN, it is mandatory to set the ONS 15216 EDFA2 IP address through a local serial communication interface using the RS-232 (EIA/TIA-232) port on the front of the module.

Step 1 If you do not know the ONS 15216 EDFA2’s IP address, subnet mask, gateway address, or host name, contact your network administrator.

Step 2 At the command prompt, enter the snmp row set local cerent15216EdfaSromIpMgmtGroup command (displayed in Example 4-3) and press Enter.

Example 4-3 Setting IP Address, Subnet Mask, Gateway Address, and Host Name

ash:hostname:ONS15216 EDFA2> snmp row set local cerent15216EdfaSromIpMgmtGroup

cerent15216EdfaSromIpMgmtEnetAddress 0.0.0.0 cerent15216EdfaSromIpMgmtEnetSubNetMask 0.0.0.0 cerent15216EdfaSromIpMgmtDefaultRouterAddress 0.0.0.0 cerent15216EdfaSromIpMgmtHostName ""

Because row set is being used in this command, the user is prompted row by row to enter the IP address, the subnet mask, the gateway address, and the host name (community ID).

Step 3 The changes must be saved prior to terminating the session. See “Save Changes” section on page 4-11.

Step 4 The system must be rebooted to make the IP address active. Use the processor reset command. (See “processor reset Command” section on page 6-12.)

4.3 Log In via LAN Port Using Telnet (Optional)

Provisioning of the ONS 15216 EDFA2 can be accomplished entirely through the RS-232 (EIA/TIA-232) port using CLI commands. After an IP address is assigned, it may be easier to provision the ONS 15216 EDFA2 using Telnet or an SNMP manager. A Telnet client is needed for CLI commands over IP. A generic SNMP manager is required for SNMP management over IP. After connecting the ONS 15216 EDFA2 to the network through its RJ-45 LAN port (see “LAN Interface (Ethernet)” section on page 3-14), the user can configure the module to accept SNMP and CLI commands via Telnet using the following procedure:

Step 1 Connect to the LAN port on the front panel. See “LAN Connection Procedure” section on page 3-15.

Step 2 Click the Microsoft Windows Start menu and select Run.

Step 3 In the text field, type the following:

telnet <ONS 15216 EDFA2 IP address> 8023

Specifying port 8023 ensures login through the ASH shell. If no port is specified, the

ONS 15216 EDFA2 responds in the shell that the ONS 15216 EDFA2 is set to. (TL1 is the default shell.)

Cisco ONS 15216 EDFA2 Operations Guide

78-16033-01 4-3