Siemens S323, S223 user manual Disabling Stacking, Displaying Stacking Status

UMN:CLI	User Manual
	SURPASS hiD 6615 S223/S323 R1.5

8.10.3Disabling Stacking

To disable stacking, use the following command.

Command	Mode	Description
no stack	Global	Disables the stacking function

8.10.4Displaying Stacking Status

Command	Mode	Description
show stack	Enable	Shows a configuration of stacking
	Global

8.10.5Accessing to Slave Switch from Master Switch

After configuring all stacking configurations, it is possible to configure and mange by ac- cessing to Slave switch from Master switch.

To access to Slave switch from Mater switch, use the following command in Bridge con- figuration mode.

Command	Mode	Description
rcommand NODE	Global	Accesses to a slave switch.
		NODE: node number

NODE means node ID from configuring stacking in Slave switch. If you input the above command in Mater switch, Telnet connected to Slave switch is displayed and it is possible to configure Slave switch using DSH command. If you use the exit command in Telnet, the connection to Slave switch is down.

8.10.6Sample Configuration

[Sample Configuration 1] Configuring Stacking

The following is a stacking configuration by designating SWITCH A as a master and SWITCH B as a slave.

Switch A

Master Switch

Manage with the same

IP address

Switch B

Slave Switch

Step 1

Assign IP address in Interface configuration mode of Switch and enable interface using “no shutdown” command. In order to enter into Interface configuration mode, you should

272 A50010-Y3-C150-2-7619