Siemens S223, S323 Enabling Interface, Disabling Interface, Interface Configuration Mode

User Manual	UMN:CLI
SURPASS hiD 6615 S223/S323 R1.5

place with TCP/IP through SNMP or telnet, it requires IP address.

You can enable interface to communicate with switch interface on network and assign IP address as the following:

•Enabling Interface

•Disabling Interface

•Assigning IP Address to Network Interface

•Static Route and Default Gateway

•Displaying Forwarding Information Base(FIB) Table

•Forwarding Information Base(FIB) Retain

•Displaying Interface

•Sample Configuration

4.3.1Enabling Interface

To assign an IP address to an interface, you need to enable the interface first. If the inter- face is not enabled, you cannot access it from a remote place, even though an IP address has been assigned.

To display if interface is enabled, use the command, show running-config.

Interface Configuration Mode

To open Interface Configuration mode of the interface you are about to enable interface, use the following command.

Command	Mode	Description
interface INTERFACE	Global	Opens Interface Configuration mode of the interface.

To enable the interface, use the following command.

Command	Mode	Description
no shutdown	Interface	Enables the interface on Interface Configuration mode.

The following is an example of enabling interface on Interface Configuration mode.

SWITCH# configure terminal

SWITCH(config)# interface 1

SWITCH(config-if)# no shutdown

SWITCH(config-if)#

4.3.2Disabling Interface

To disable the interface, use the following commands on Interface Configuration mode. Before disabling interface on Interface Configuration mode, you should open the mode, and then use the follow command.

Command	Mode	Description
shutdown	Interface	Disables an interface on Interface Configuration mode.

A50010-Y3-C150-2-7619 57