Siemens S223, S323 user manual Port Basic, Selecting Port Type, Show port Ports

User Manual	UMN:CLI
SURPASS hiD 6615 S223/S323 R1.5

5 Port Configuration

It is possible for user to configure basic environment such as auto-negotiate, transmit rate, and flow control of the hiD 6615 S223/S323 port. Also, it includes instructions how to con- figure port mirroring and port as basic.

5.1Port Basic

It is possible to configure default environment of port such as port state, speed. To con- figure port, you need to open Bridge Configuration mode by using the command, bridge, on Global Configuration mode. When you begin Bridge Configuration mode, system prompt will be changed from SWITCH(config)# to SWITCH(bridge)#.

SWITCH(config)# bridge

SWITCH(bridge)#

The hiD 6615 S223/S323 have 12 electrical and optical combo 100/1000Base-X Ethernet ports. The direction to configure each port is different depending on its features. Read the below instruction carefully and follow it before you configure.

Refer to below figure for front interfaces of hiD 6615 S223/S323.

LNK MGMT ACT

RUN	1	2	3	4	5	6	7	8	9	10	11 12	1	2	3	4	5	6	7	8
RPU	L/A
DIAG	1 G
S323	RX CONSOLE TX

				SURPASS
9	10	11	12	hiD 6615

Fig. 5.1 hiD 6615 S223/S323 Interface

To display the configuration of the physical port, use the following command.

Command	Mode	Description
	Enable
show port [PORTS]	Global	Shows port configuration.
	Bridge

When you use the command, show port command, if you input letter at port-number, the message, “% Invalid port: port'” will be displayed, and if you input wrong number, the message, “% Invalid range: 100 [1-18]” will be displayed.

SWITCH(bridge)# show port port %Invalid port: port SWITCH(bridge)# show port 100 %Invalid range: 100 [1-18] SWITCH(bridge)#

5.1.1Selecting Port Type

User should select port type due to the hiD6615 S223/S323 switch ports have two types (RJ45 and SFP). To select port type, use the following command.

A50010-Y3-C150-2-7619 73