Siemens S223 Snmp Trap Host, Snmp Trap Mode, To set an Snmp trap host, use the following command

User Manual	UMN:CLI
SURPASS hiD 6615 S223/S323 R1.5

7.1.8.1SNMP Trap Host

To set an SNMP trap host, use the following command.

Command Mode Description

snmp trap-host

IP-ADDRESS [COMMUNITY]

snmp trap2-host

Specifies IP address of an SNMP trap host.

Global

IP-ADDRESS [COMMUNITY]

snmp inform-trap-host

Specifies IP address of SNMP information trap host.

IP-ADDRESS [COMMUNITY]

i

You need to configure an SNMP trap host with the snmp trap2-hostcommand, if you manage the switch via the ACI-E.

To delete a specified SNMP trap host, use the following command.

Command	Mode	Description
no snmp trap-host IP-ADDRESS		Deletes a specified SNMP trap host.
	Global
no snmp trap2-host IP-ADDRESS
no snmp inform-trap-host IP-ADDRESS		Deletes a specified information trap host.

i

You can set maximum 16 SNMP trap hosts with inputting one by one.

The following is an example of setting an SNMP trap host.

SWITCH(config)# snmp trap-host10.1.1.3

SWITCH(config)# snmp trap-host20.1.1.5

SWITCH(config)# snmp trap-host30.1.1.2

SWITCH(config)#

7.1.8.2SNMP Trap Mode

To select an SNMP trap-mode, use the following command.

Command	Mode	Description
snmp trap-mode {alarm-report	Global	Selects SNMP trap-mode according to user’s network
event}		environment. ( alarm-report or event)

i

•“event” trap-modeis set by default. It means that Dasan trap OID will be used upon sending the trap if the trap-mode is “event”

•“alarm-report”trap-modewill be used form SLE MIB OID which is Siemens private OID.

In order to manage hiD 6615 S223/S323 using ACI-E, the trap-mode must be set as “alarm-report”. Otherwise, ACI-E would not recognize any traps set from the hiD 6615 S223/S323.

A50010-Y3-C150-2-7619 109