Siemens S323, S223 PIM-SM Registration, 4.3, Ignoring RP Priority, Rate Limit of Register Message

UMN:CLI	User Manual
	SURPASS hiD 6615 S223/S323 R1.5

9.3.4.3	KAT (Keep Alive Time) of RP
	You can configure KAT for (S, G) states at RP to monitor PIM Register packets, overriding
	the generic KAT timer value.
	Command	Mode	Description
	ip pim rp-register-kat <1-65535>		Configures Keep Alive Time.
		Global	1-65535: time
	no ip pim rp-register-kat		Disables a KAT configuration.

9.3.4.4	Ignoring RP Priority
	To ignore the RP-SET priority value, and use only the hashing mechanism for RP selec-
	tion, use the following command. It is used to inter-operate with older Cisco IOS versions.
	Command	Mode	Description
	ip pim ignore-rp-set-priority	Global	Ignores the PR-SET priority value.
	no ip pim ignore-rp-set-priority		Deletes the priority ignoring configuration.

9.3.5PIM-SM Registration

9.3.5.1Rate Limit of Register Message

You can configure the rate of register packets sent by the designated router (DR), in units of packets per second. Enabling this command will limit the load on the DR and RP at the expense of dropping those register messages that exceed the set limit. Receivers may experience data packet loss within the first second in which register messages are sent from bursty sources.

The configured rate is per (S, G) state, not a system wide rate.

Command	Mode	Description
ip pim register-rate-limit		Configures the rate of register packets.
		1-65535: the maximum number of packets that can be
<1-65535>	Global
		sent per second.
no ip pim register-rate-limit		Disables the limit configuration.

9.3.5.2Registeration Suppression Time

Use this command to configure the register-suppression time, in seconds, overriding the default value of 60 seconds. Configuring this value modifies register-suppression time at the DR, and configuring this value at the RP modifies the RP-keepalive-period value if the ip pim re-register-katcommand is not used.

310 A50010-Y3-C150-2-7619