Siemens S323, S223 Creating Vlan, Specifying Pvid, Assigning Port to Vlan, Deleting Vlan

UMN:CLI	User Manual
	SURPASS hiD 6615 S223/S323 R1.5

8.1.1.1Creating VLAN

To configure VLAN on user’s network, use the following command.

Command	Mode	Description
vlan create VLANS	Bridge	Creates new VLAN by assigning VLAN ID:
		VLANS: enter the number of VLAN ID (from 1 to 4094).

i

The variable VLANS is a particular set of bridged interfaces. Frames are bridged only among interfaces in the same VLAN.

8.1.1.2Specifying PVID

By default, PVID 1 is specified to all ports. You can also configure PVID. To configure PVID in a port, use the following command.

Command	Mode	Description
		Configures VLAN PVID:
vlan pvid PORTS PVIDS	Bridge	PORTS: enter the port numbers.
		PVIDS: enter the PV IDs (1 to 4094 multiple entries
		possible).

8.1.1.3Assigning Port to VLAN

To assign a port to VLAN, use the following command.

Command	Mode	Description
vlan add VLANS PORTS {tagged		Assigns a port to VLAN:
		VLANS: enter the VLAN ID.
untagged}
		PORTS: enter the port number.
	Bridge
		Deletes associated ports from specified VLAN:
vlan del VLANS PORTS		VLANS: enter the VLAN ID.
		PORTS: enter the port number to be deleted.

i

When you assign several ports to VLAN, you have to enter each port separated by a comma without space or use dash mark “-“ to arrange port range.

8.1.1.4Deleting VLAN

To delete VLAN, use the following command.

Command	Mode	Description
no vlan VLANS	Bridge	Deletes VLAN, enter the VLAN ID to be deleted.

i

When you delete VLAN, all ports must be removed from VLAN before, see the below procedure.

180 A50010-Y3-C150-2-7619