Siemens S223, S323 user manual Applying Rule, Modifying and Deleting Rule

User Manual	UMN:CLI
SURPASS hiD 6615 S223/S323 R1.5

To delete a specified rule action (no-match), use the following command.

Command	Mode	Description
no no-match deny
no no-match redirect
no no-match mirror
	Rule	Deletes a specified rule action.
no no-match dscp
no no-match cos
no no-match ip-prec
no no-match copy-to-cpu

7.6.2.5Applying Rule

After configuring rule using the above commands, apply it to the system with the following command. If you do not apply the rule to the system, all specified rules will be lost.

To save and apply a rule, use the following command.

Command	Mode	Description
apply	Rule	Applies a rule to the system.

i

1.The switch performs a detailed plausibility check and rejects the rule if the configuration is incomplete, contains bad or unsupported values or conflicts to other rules. In this case, the switch informs about the reason and the operator may correct the values

2.The switch may reject a rule with the message “% Already exist rule” allthough the name will not be listed by command, show rule. Unfortunately, the entered name in this case interferes with the name of an internally managed rule.

Remedy: Select another name for the rule (e.g. add a prefix).

3.All previously entered values remain valid after successful (or unsuccessful) execution of command, apply. That is, if several rules being different only in one

value should be created, then only the one changed value needs to be entered again.

7.6.2.6Modifying and Deleting Rule

To modify a rule, use the following command.

Command	Mode	Description
rule NAME modify	Global	Modifies a rule, enter a rule name.

To delete a rule, use the following command.

Command	Mode	Description
no rule [NAME]	Global	Deletes a rule, enter a rule name optionally.

A50010-Y3-C150-2-7619 145