Siemens S223 Maximum Number of Groups, Igmp Query Configuration, Vlan Vlan port Port reporter

User Manual	UMN:CLI
SURPASS hiD 6615 S223/S323 R1.5

IGMP cache, but the switch is not a member. Therefore it can support fast switching.

To configure IGMP static Join, use the following command.

Command		Mode	Description
ip igmp static-group	A.B.C.D		Configures IGMP static join setting.
vlan VLAN port PORT reporter
			A.B.C.D: group address
A.B.C.D
no ip igmp static-group		Global
[A.B.C.D] [vlan VLAN]
			Disables the IGMP static join configuration.
no ip igmp static-group A.B.C.D
vlan VLAN port PORT reporter
A.B.C.D

9.2.2.2Maximum Number of Groups

Hosts on a subnet serviced by a particular interface have the access to join certain multi- cast groups. These multicast groups can be controlled by the ip igmp access-groupcommand.

To control the multicast groups on an interface, use the following command.

Command	Mode	Description
ip igmp access-group {<1-99>		Sets an IGMP access group.
		1-99: access list number
WORD}	Interface
		WORD: IP named standard access list
no ip igmp access-group		Disables groups on interfaces.

9.2.2.3IGMP Query Configuration

Multicast routers send host membership query messages (host query messages) to dis- cover which multicast groups have members on the attached networks of the router. Hosts respond with IGMP report messages indicating that they wish to receive multicast packets for specific groups (indicating that the host wants to become a member of the group). Host query messages are addressed to the all-hosts multicast group, which has the address 224.0.0.1, and has an IP time-to-live (TTL) value of 1.

The designated router for a LAN is the only router that sends IGMP host query messages. For IGMP Version 2, the designated querier is the router with the lowest IP address on the subnet. If the router hears no queries for the timeout period, it becomes the querier.

To configure an IGMP query interval, use the following command.

Command	Mode	Description
ip igmp query-interval		Configures the IGMP query interval.
		1-18000: frequency at which IGMP host query mes-
<1-18000>	Interface
		sages are sent (unit: second)
no ip igmp query-interval		Returns to the default value. (125)

Use this command to configure the timeout period before the router takes over as the

A50010-Y3-C150-2-7619 285