Siemens S323, S223 user manual Link Aggregation Control Protocol Lacp, Disabling Port Trunk

UMN:CLI	User Manual
	SURPASS hiD 6615 S223/S323 R1.5

enter. It is decided with Source IP address, Destination IP address, Source MAC address, Destination Mac address and the user could get information of packets to decided packet route.

•dstip: Destination IP address

•dstmac: Destination MAC address

•srcdstip: Refer to both Source IP address and Destination IP address

•srcdstmac: Refer to both Source MAC address and Destination MAC address

•srcip: Source IP address

•srcmac: Source MAC address.

The port designated as member port of port trunk is automatically deleted from existing VLAN. Therefore, if member port and aggregated port exist in other VLAN, VLAN configu- ration should be changed for the aggregated port.

8.2.1.2Disabling Port Trunk

To remove the configured port trunk from specified trunk group, use the following com- mand.

Command	Mode	Description
no trunk<0-5>PORTS	Bridge	Releases a configured trunk port.
no trunk distmode <0-5>

i

If the user deleted member port from logical port or release port trunk, they are automati- cally contained as default VLAN.

8.2.1.3Displaying Port Trunk Configuration

To display a configuration of port trunk, use the following command.

Command	Mode	Description
	Enable
show trunk	Global	Shows a configuration for trunk.
	Bridge

8.2.2Link Aggregation Control Protocol (LACP)

i

Link Aggregation Control Protocol (LACP) is the function of using wider bandwidth by ag- gregating more than two ports as a logical port as previously stated port trunk function. If the integrated port by configuring from port trunk is in other VLAN which is different from VLAN where existing member port is originally belong to, it should be moved to VLAN where the existing member port is belong to. However, the integrated port configured by LACP is automatically added to appropriate VLAN.

The LACP aggregator from LACP could support up to 14 so that it is possible to input ag- gregator number from 0 to 13, and group ID of port trunk and aggregator number of LACP cannot be configured repeatedly.

The following explains how to configure LACP.

194 A50010-Y3-C150-2-7619