Siemens S323, S223 user manual Snmp Version 3 User, Snmp Trap, Lowing command, Snmp access

UMN:CLI	User Manual
	SURPASS hiD 6615 S223/S323 R1.5
	To display a granted an SNMP group to access a specific SNMP view record, use the fol-

lowing command.

Command	Mode	Description
show snmp access	Enable	Shows a granted an SNMP group to access a specific
	Global	SNMP view record

The following is an example of permission to accessing an SNMP view record.

SWITCH(config)#		access regroup v1 test none none
SWITCH(config)# snmp
SWITCH(config)# show		snmp access
Access List
GroupName	SecModel SecLevel ReadView		WriteView	NotifyView

------------------------------------------------------------------------------

rogroup	v1	noauth TEST	none	none
SWITCH(config)#

7.1.7SNMP Version 3 User

In SNMP version 3, you can register an SNMP agent as user. If you register SNMP ver- sion 3 user, you should configure it with the authentication key.

To create/delete SNMP version 3 user, use the following command.

Command	Mode	Description
		Creates SNMP version 3 user.
snmp user USER {md5 sha}		USER : enters user name
AUTH-KEY [des PRIVATE-KEY]	Global	AUTH-KEY: Authentication passphrase (min length:8)
		PRIVATE-KEY: Privacy passphrase (min length: 8)
no snmp user USER		Deletes a registered SNMP version 3 user.

To display SNMP version 3 user, use the following command.

Command	Mode	Description
show snmp user	Enable	Displays SNMP version 3 user.
	Global

7.1.8SNMP Trap

SNMP trap is an alert message that SNMP agent notifies SNMP manager about certain problems. If you configure SNMP trap, switch transmits pertinent information to network management program. In this case, trap message receivers are called trap host.

108 A50010-Y3-C150-2-7619