Siemens S323, S223 Command Mode Description Clear mac, Clear mac Name Port, No mac Name

UMN:CLI	User Manual
	SURPASS hiD 6615 S223/S323 R1.5

i

To remove registered dynamic MAC addresses from the MAC table, use the following command.

Command	Mode	Description
clear mac		Clears dynamic MAC addresses.
clear mac NAME		Clears dynamic MAC addresses.
		Clears dynamic MAC addresses.
clear mac NAME PORT	Enable	NAME: enter the bridge name.
	Global	PORT: enter the port number.
	Bridge
		Clears dynamic MAC addresses.
clear mac NAME PORT		NAME: enter the bridge name.
MACADDR		PORT: enter the port number.
		MACADDR: enter the MAC address.

To remove static MAC addresses manually registered by user from the MAC table, use the following command.

Command	Mode	Description
no mac		Deletes static MAC addresses.
no mac NAME		Deletes static MAC addresses, enter the bridge name.
		Deletes static MAC addresses.
no mac NAME PORT		NAME: enter the bridge name.
	Bridge	PORT: enter the port number.
		Deletes a specified static MAC address.
no mac NAME PORT MACADDR		NAME: enter the bridge name.
		PORT: enter the port number.
		MACADDR: enter the MAC address.

To display a MAC table in the switch, use the following command.

Command	Mode	Description
	Enable	Shows switch MAC address, selection by port number
		(subscriber port only):
show mac NAME [PORT]	Global
		NAME: enter the bridge name
	Bridge
		PORT: select the port number.

There are more than a thousand of MAC addresses in MAC table. And it is difficult to find information you need at one sight. So, the system shows certain amount of addresses displaying –more– on standby status. Press any key to search more. After you find the in- formation, you can go back to the system prompt without displaying the other table by pressing <q>.

162 A50010-Y3-C150-2-7619