Siemens S323, S223 Snmp Com2sec, Snmp Group, Following is an example of configuring Snmp com2sec

UMN:CLI	User Manual
	SURPASS hiD 6615 S223/S323 R1.5

7.1.3SNMP Com2sec

SNMP v2 authorizes the host to access the agent according to the identity of the host and community name. The command, com2sec, specifies the mapping from the identity of the host and community name to security name.

To configure an SNMP security name, use the following command.

Command	Mode	Description
		Specifies the mapping from the identity of the host and
snmp com2sec SECURITY		community name to security name, enter security and
{IP-ADDRESS IP-ADDRESS/M}		community name.
COMMUNITY	Global	SECURITY: security name
		COMMUNITY: community name
		Deletes a specified security name, enter the security
no snmp com2sec SECURITY		name.
		SECURITY: security name
show snmp com2sec	Enable	Shows a specified security name.
	Global

The following is an example of configuring SNMP com2sec.

SWITCH(config)# snmp com2sec TEST 10.1.1.1 PUBLIC

SWITCH(config)# show snmp com2sec

Com2Sec List

SecName Source Community

---------------------------------------

com2sec TEST	10.1.1.1 PUBLIC
SWITCH(config)#

7.1.4SNMP Group

You can create an SNMP group that can access SNMP agent and its community that be- longs to a group.

To create an SNMP group, use the following command.

Command	Mode	Description
snmp group GROUP {v1 v2c		Creates SNMP group, enter the group name.
		GROUP: group name
v3} SECURITY
	Global	SECURITY: security name
no snmp group GROUP {v1 v2c		Deletes SNMP group, enter the group name.
v3} SECURITY		GROUP: group name
show snmp group	Enable	Shows a created SNMP group.
	Global

106 A50010-Y3-C150-2-7619