Siemens S323, S223 user manual RP Information, Static RP for Certain Group, Ip pim bsr-candidate

UMN:CLI	User Manual
	SURPASS hiD 6615 S223/S323 R1.5

priority, becomes BSR among them. If there are routers, which have same priority, then one router, which has the highest IP address, becomes BSR.

It is possible to configure the following messages, which are included in candidate-BSR message.

Since it is possible to assign several IP addresses in hiD 6615 S323, the switch may have several IP addresses assigned. User can select one IP address among several IP ad- dresses to be used in switch as candidate-BSR.

When there are same priorities to compare candidate-BSR, IP address is compared through Hash. User can configure Hash-mask to apply Hash.

If you decide BSR among candidate-BSRs, priority in Bootstrap message is compared to decide it. The highest priority of candidate-BSR becomes BSR. In order to configure prior- ity of Bootstrap message, use the following command.

To configure candidate-BSR, use the following command.

Command	Mode	Description
		Gives the switch the candidate BSR status.
ip pim bsr-candidate	Global	INTERFACE: interface name
INTERFACE [<0-32>] [<0-255>]		0-32: hash mask length for RP selection
		0-255: priority for candidate bootstrap switch

To disable assigned IP address in candidate-BSR, use the following command.

Command	Mode	Description
no ip pim bsr-candidate	Global	Disables .the configuration of BSR-candidate.

You can clear all RP sets learned through the PIM Bootstrap Router (BSR) using the fol- lowing command.

Command	Mode	Description
clear ip pim sparse-mode bsr rp-	Global	Clears all RP sets.
set *

9.3.4RP Information

After deciding BSR on multicast network, candidate-RP routers send RP message to BSR. Candidate-RP message includes priority, IP address, and multicast group. Then, BSR adds the received candidate-RP information to Bootstrap message and transmit to an- other PIM router. Through this Bootstrap message, RP of multicast group is decided. All routers belonged in multicast network can become candidate-RP and routers which gen- erally consist candidate-BSR are supposed to consist candidate-RP. It is possible to con- figure the following information, which is included in candidate-RP message.

9.3.4.1Static RP for Certain Group

You can configure several IP addresses on the hiD 6615 S323. Therefore, you need to

308 A50010-Y3-C150-2-7619