User ManualUMN:CLI SURPASS hiD 6615 S223/S323 R1.5

open Interface configuration mode of VLAN to register as a switch group for stacking.

The following is an example of configuring Interface of switch group as 1.

SWITCH_A# configure terminal

SWITCH_A(config)# interface 1

SWITCH_A(interface)# ip address 192.168.10.1/16

SWITCH_A(interface)# no shutdown

SWITCH_A(interface)#

i

If there are several switches, rest of them are managed by a single IP address of Master switch. Therefore you don’t need to configure IP address in Slave switch.

Step 2

Configure Switch A as Master switch. Configure VLAN to belong in the same switch group after registering Slave switch, configure it as a Master switch.

<Switch A – Master Switch>

SWITCH_A(config)# stack master

SWITCH_A(config)# stack device default

SWITCH_A(config)# stack add 00:d0:cb:22:00:11

Step 3

Configure VLAN in order to belong to the same switch group in Switch B registered by Master switch as Slave switch and configure as a Slave switch.

<Switch B – Slave Switch>

SWITCH_B(config)# stack slave

SWITCH_B(config)# stack device default

Step 4

Check the configuration. The information you can check in Master switch and Slave switch is different as below.

<Switch A – Master Switch>

SWITCH_A(config)# show stack

 

 

 

 

device

: default

 

 

 

 

 

node ID : 1

 

 

 

 

 

node

MAC address

status

type

name

port

 

1

00:d0:cb:0a:00:aa

active

SURPASS hiD 6615

S223/S323 SWITCH_A

24

2

00:d0:cb:22:00:11

active

SURPASS hiD 6615

S223/S323 SWITCH_B

24

SWITCH_A(config)#

<Switch B – Slave Switch>

SWITCH_B(config)# show stack device : default

node ID : 2 SWITCH_B(config)#

A50010-Y3-C150-2-7619

273

Page 273
Image 273
Siemens S223, S323 user manual A50010-Y3-C150-2-7619 273, SWITCHA# configure terminal, SWITCHAconfig# stack device default