Siemens S323, S223 user manual Operating Mode of Member Port, 196 A50010-Y3-C150-2-7619

UMN:CLI	User Manual
	SURPASS hiD 6615 S223/S323 R1.5

i

•dstip: Destination IP address

•dstmac: Destination MAC address

•srcdstip: Runs by reference to both Source IP address and Destination IP address

•srcdstmac: Source MAC address and Destination MAC address

•srcip: Source IP address

•srcmac: Source MAC address.

For the hiD 6615 S223/S323, srcdstmac (source MAC address and destination MAC ad- dress) is basically used to decide packet route.

After configuring aggregator, you should configure packets transmitting aggregator port. The following is the command of configuring packets transmitting aggregator port.

Command		Mode	Description
lacp aggregator distmode	AG-		Defines packets transmitted by way of aggregator
GREGETIONS {srcmac dstmac
		Bridge	which is a logical aggregated port:
srcdstmac srcip dstip
			AGGREGATIONS: select the aggregator ID <0-13>.
srcdstip}

To disable configuring packets, use the following command.

Command	Mode	Description
no lacp aggregator	Bridge	Deletes destination MAC address, select the aggrega-
AGGREGETIONS		tor ID.

8.2.2.3Operating Mode of Member Port

i

After configuring member port, configure the mode of member port. There are two kinds of mode Active mode and Passive mode in member port. The port of Passive mode starts LACP when there’s Active mode on the port of opposite switch. The priority of Active mode is higher that that of Passive mode so that the port of Passive mode follows the port of Active mode.

If each member port of the connected switch is configured as Active mode and Passive mode, Active mode is the standard. If both switches are configured as Passive mode, link for member ports of two switches is not realized.

To configure the mode of member port, use the following command.

Command	Mode	Description
lacp port activity PORTS {active	Bridge	Configure the mode of member port, select the mem-
passive}		ber port number. (default: active)

To delete an operating mode of configured member port, use the following command.

Command	Mode	Description
no lacp port activity PORTS	Bridge	Deletes operation mode of configured member port,
		select the member port number.

196 A50010-Y3-C150-2-7619