Siemens S323, S223 user manual Snmp Alarm, Displaying Snmp Trap, Enabling Alarm Notification

UMN:CLI	User Manual
	SURPASS hiD 6615 S223/S323 R1.5

7.1.8.5Displaying SNMP Trap

To display a configuration of SNMP trap, use the following command.

Command	Mode	Description
show snmp trap	Enable	Shows a configuration of SNMP trap.
	Global

The following is an example of configuring IP address 10.1.1.1 as trap-host, 20.1.1.1 as trap2-host and 30.1.1.1 as inform-trap-host.

SWITCH(config)# snmp trap-host10.1.1.1

SWITCH(config)# snmp trap2-host20.1.1.1

SWITCH(config)# snmp inform-trap-host 30.1.1.1

SWITCH(config)# show snmp trap

Trap-Host List

Host Community

------------------------------------------
inform-trap-host 30.1.1.1
trap2-host		20.1.1.1
trap-host		10.1.1.1
Trap List
Trap-type		Status
--------------------------
auth-fail		enable
cold-start		enable
cpu-threshold		enable
port-threshold		enable
dhcp-lease		enable
power		enable
module		enable
fan	enable
temp-threshold		enable
SWITCH(config)#

7.1.9 SNMP Alarm

The hiD 6615 S223/S323 provides an alarm notification function. The alarm will be sent to a SNMP trap host whenever a specific event in the system occurs through CLI and ACI-E. You can also set the alarm severity on each alarm and make the alarm be shown only in case of selected severity or higher. This enhanced alarm notification allows system ad- ministrators to manage the system efficiently.

7.1.9.1Enabling Alarm Notification

To configure whether the switch enable transmitting SNMP alarm or not, use the following command.

Command	Mode	Description
snmp notify-activity {enable	Global	Enables/disables an alarm notification on CLI or ACI-E.
disable}		(default: disable)

112 A50010-Y3-C150-2-7619