Siemens S223, S323 user manual Facility Code, Syslog Bind Address, A50010-Y3-C150-2-7619 137

User Manual	UMN:CLI
SURPASS hiD 6615 S223/S323 R1.5

The following is an example of configuring syslog message to send all logs higher than notice to remote host 10.1.1.1 and configuring local1.info to transmit to console.

SWITCH(config)# syslog output notice remote 10.1.1.1

SWITCH(config)# syslog output priority local1 info console

SWITCH(config)# show syslog

System logger on running!

info	local	volatile
info	local	non-volatile
notice	remote 10.1.1.1
local1.info	console
SWITCH(config)#

7.5.2Facility Code

You can set a facility code of the generated syslog message. This code make a syslog message distinguished from others, so network administrator can handle various syslog messages efficiently.

To set a facility code, use the following command.

Command	Mode	Description
syslog local-code <0-7>	Global	Sets a facility code.
no syslog local-code		Deletes a specified facility code.

The following is an example of configuring priority of all syslog messages which is trans- mitted to remote host 10.1.1.1, as the facility code 0.

SWITCH(config)# syslog output err remote 10.1.1.1

SWITCH(config)# syslog local-code 0

SWITCH(config)# show syslog

System logger on running!

info	local volatile
info	local non-volatile
err	remote 10.1.1.1
local_code	0
SWITCH(config)#

7.5.3Syslog Bind Address

You can specify IP address to attach to the syslog message for its identity. To specify IP address for syslog identity, use the following command.

Command	Mode	Description
syslog bind-address A.B.C.D	Global	Specifies IP address for a syslog message identity.
no syslog bind-address		Deletes a specified binding IP address.

A50010-Y3-C150-2-7619 137