Siemens S223, S323 FTP Upgrade, Uploads the new system software using the following command

User Manual	UMN:CLI
SURPASS hiD 6615 S223/S323 R1.5

Step 4

Reboot the system with the new system software using the following command.

Command	Mode	Description
reboot [os1 os2]	Boot	Reboots the system with specified system software.
		os1 os2: the area where the system software is stored

If the new system software is a current standby OS, just exit the boot mode, then the in- terrupted system boot will be continued again with the new system software.

To exit the boot mode, use the following command.

Command	Mode	Description
exit	Boot	Exits the boot mode.

11.3FTP Upgrade

The system software of the hi can be upgraded using FTP. This will allow network or sys- tem administrators to remotely upgrade the system with the familiar interface.

To upgrade the system software using FTP, perform the following step-by-step instruction:

Step 1

Connect to the hiD 6615 S223/323 with your FTP client software. To login the system, you can use the system user ID and password.

Note that you must use the command line-based interface FTP client software when up-

! grading the hiD 6615 S223/323. If you use the graphic-based interface FTP client soft- ware, the system cannot recognize the upgraded software.

Step 2

Set the file transfer mode to the binary mode using the following command.

Command	Mode	Description
bin	FTP	Sets the file transfer mode to the binary mode.

Step 3

Enable to print out the hash marks as transferring a file using the following command.

Command	Mode	Description
hash	FTP	Prints out the hash marks as transferring a file.

Step 3

Uploads the new system software using the following command.

Command	Mode	Description
		Uploads the system software.
put FILENAME {os1 os2}	FTP	FILENAME: system software file name
		os1 os2: the area where the system software is stored

A50010-Y3-C150-2-7619 377