JVC RX-5032VSL manual Troubleshooting, English, Problem, Possible Cause, Solution

Troubleshooting

Use this chart to help you solve daily operational problems. If there is any problem you cannot solve, contact your JVC service center.

PROBLEM	POSSIBLE CAUSE	SOLUTION
The power does not come on.	The power cord is not plugged in.	Plug the power cord into an AC outlet.
No sound from speakers.	Speaker signal cables are not	Check speaker wiring and reconnect if
	connected.	necessary.
	An incorrect source is selected.	Select the correct source.
	Muting is activated.	Press MUTING on the remote control to cancel
		the mute.
	An incorrect input mode (analog or	Select the correct input mode (analog or
	digital) is selected.	digital).
	Connections are incorrect.	Check connections.
		For analog connections, see pages 7 and 8.
		For digital connections, see page 9.
	Speaker signal cables are not connected	Check speaker wiring and reconnect if
	properly.	necessary.
Sounds from speakers are heard	The speaker output level is not set	Adjust the speaker output level (see pages 17
unequally.	correctly.	– 19).
No test tone is available.	The speakers are deactivated.	Press SPEAKERS ON/OFF on the front panel
		to activate the speakers (see page 12).
Continuous hiss or buzzing during FM	Incoming signal is too weak.	Connect an outdoor FM antenna or contact
reception.		your dealer.
	The station is too far away.	Select a new station.
	The wrong antenna is being used.	Check with your dealer to be sure you have the
		correct antenna.
	Antennas are not connected properly.	Check connections.
Occasional cracking noise during FM	Ignition noise from automobiles.	Move the antenna farther from automobile
reception.		traffic.
“OVERLOAD” starts flashing on the	Speakers are overloaded because of	1. Press STANDBY/ON	on the front panel
display.	high volume.	to turn off the receiver.
		2. Stop the playback source.
		3. Turn on the receiver again, and adjust the
		volume.
	Speakers are overloaded because of	Press STANDBY/ON	on the front panel,
	short circuit of speaker terminals.	then check the speaker wiring.
		If “OVERLOAD” does not disappear after
		turning on the receiver again, unplug the AC
		power cord, then plug it back in again.
		If speaker wiring is not short-circuited, contact
		your dealer.
“DSP MICOM NG” starts flashing on	The built-in microcomputer is not	Press STANDBY/ON	on the front panel to
the display.	functioning correctly.	turn off the receiver. After unplugging the
		power cord, consult your dealer.
The STANDBY lamp lights up after	The receiver is overloaded because of a	Press STANDBY/ON	on the front panel to
turning on the power, but soon the	high voltage.	turn off the receiver. After unplugging the
receiver turns off (into standby mode).		power cord, consult your dealer.
Remote control does not work.	There is an obstruction in front of the	Remove the obstruction.
	remote sensor on the receiver.
	Batteries are weak.	Replace batteries in the remote control.
Remote control does not operate as	The remote control is not ready for your	Press SOUND or source selection buttons first,
you intend.	intended operation.	then press the button you want to use.
		(See pages 18 and 29 – 31).

English

32